I am building the clipped version (22') of the Skybolt (plans from Steen). Working on the upper spars and am drilling the spars for the al. plates and also the I-strut hole. There is a 5/8 center to center dimension between the 1/4 I-strut hole and the 1" flying wire hole which means they will just touch each other in the center of the spar. When I looked at the standard wing drawing ('90 rev.), the dimension between the 2 holes is 3/4 which will leave 1/8 between the two. Anybody run into this issue that has built the 22' wing version and what did you do? Thinking of moving the I-strut in-board 1/8 to 1/4 inch (would do both top and bottom wing the same). This would leave the flying wire pins per the drawing.
-
Become a Subscribing Member today!
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.
Why become a Subscribing Member?
- In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
- We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
- Annual membership also comes with two BiplaneForum.com decals.
Become a Subscribing Member and access the Biplane Forum in full!
I-strut/flying wire pin interference
- Thread starter ccoffin
- Start date
- Joined
- Jan 1, 2008
- Messages
- 1,997
- Reaction score
- 902
