• Become a Subscribing Member today!

    The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.

    Why become a Subscribing Member?

    • In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
    • We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
    • Annual membership also comes with two BiplaneForum.com decals.

    Become a Subscribing Member and access the Biplane Forum in full!

    Subscribe Now
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Rear Flying Wire Fittings
Jerry

Rear Flying Wire Fittings

***Update: 8-14-09: The general consensus is to not make this fitting in three pieces. It should either be bent out of a flat sheet of 4130 or milled out of a solid piece of steel.***

Unable to purchase the .875" x 1.25" x .o95 retangular tubing... I made these up out of .100 4130 flat stock. They still need the 5/16" holes drilled into the up-rights.
There are no comments to display.

Media information

Album
Fittings
Added by
Jerry
Date added
View count
805
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top