Getting ready to weld the main landing gear supports to the axles. The fuselage ends are already completed and welded in place. To get the supports perfectly lined up with the axles, how much tolerance do I have with the 3 inch dimension from the front landing gear support. I was hoping to be able to move the axle back about a 1/4 inch. Will that make any difference in handling on the ground.
-
Become a Subscribing Member today!
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.
Why become a Subscribing Member?
- In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
- We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
- Annual membership also comes with two BiplaneForum.com decals.
Become a Subscribing Member and access the Biplane Forum in full!
Axle location
- Thread starter ccoffin
- Start date
