New thread,
Constructing my recessed bucket seat.
I borrowed the following from another thread, that wasn't relevant to my task of "lowering my ass in the chair"
Funny!
So I got the mold from the plug this morning.
First time I tried vacuum bagging.
Trouble was, even though I waxed the heck out of it and sprayed mold release. I had to wrestle to get the plug out.!
I needed to glue pieces of foam together to build up the size of the plug. The resin got in the crack (crevices)
It was a pain in the ass
I think I'll start a new thread...this aint canopy ! It's too low!!
This picture is the same as the one I included in the canopy thread.
Later I will send a picture of the mold I made from this carved hard foam plug.
Man' I hope this works out!
If it doesn't = well' I gained from the experience at least.
Constructing my recessed bucket seat.
I borrowed the following from another thread, that wasn't relevant to my task of "lowering my ass in the chair"
Funny!
So I got the mold from the plug this morning.
First time I tried vacuum bagging.
Trouble was, even though I waxed the heck out of it and sprayed mold release. I had to wrestle to get the plug out.!
I needed to glue pieces of foam together to build up the size of the plug. The resin got in the crack (crevices)
It was a pain in the ass
I think I'll start a new thread...this aint canopy ! It's too low!!
This picture is the same as the one I included in the canopy thread.
Later I will send a picture of the mold I made from this carved hard foam plug.
Man' I hope this works out!
![DSCN0104 (800x600).jpg DSCN0104 (800x600).jpg](https://cdn.imagearchive.com/biplaneforum/data/attach/8/8262-DSCN0104-800x600-.jpg)