• Become a Subscribing Member today!

    The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.

    Why become a Subscribing Member?

    • In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
    • We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
    • Annual membership also comes with two BiplaneForum.com decals.

    Become a Subscribing Member and access the Biplane Forum in full!

    Subscribe Now

N57DF Acro 2 Chicago drill tubes

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Dennis Flamini

Well-Known Member
*
Joined
Sep 6, 2007
Messages
3,293
Reaction score
2,278

How do you drill for the bushings in the fin and stab. support tubes keeping
them aligned plumb and level?
PS; Just installed the 3 degree aileron bellcrank in the lower wing and it worked out, also had to remake aileron hinge brackets longer per new plans and then trim ailerons to match wing trailing edge.
see Youtube;

[ame]http://www.youtube.com/watch?v=nf2zFXpM62E[/ame]

Edited by: flamini2
 

Latest posts

Back
Top