• Become a Subscribing Member today!

    The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.

    Why become a Subscribing Member?

    • In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
    • We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
    • Annual membership also comes with two BiplaneForum.com decals.

    Become a Subscribing Member and access the Biplane Forum in full!

    Subscribe Now

Need help (again)…. bracing wire ends Pitts S1S

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

ssmdive

Well-Known Member
*
Joined
Mar 30, 2014
Messages
1,024
Reaction score
398
Conditional is due this month. Rear bracing wires are fine, but the clevis's are a bit pitted and it was suggested that I replace them at this time.

Anyone know if these are pretty standard parts and what they are called/sizes? I looked at ACS and well, found nothing.

I'll need a complete set for the rear - Top and bottom flying wires (8 pieces) and the front braces (2)

Guidance?
 

Latest posts

Back
Top