• Become a Subscribing Member today!

    The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.

    Why become a Subscribing Member?

    • In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
    • We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
    • Annual membership also comes with two BiplaneForum.com decals.

    Become a Subscribing Member and access the Biplane Forum in full!

    Subscribe Now

Non-standard inspection panels in Fabric

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

user 38

Well-Known Member
Joined
Aug 29, 2006
Messages
761
Reaction score
74
I am finishing the covering of the tail feathers and I want to make an square shaped inspection panel on the underneath side of the horizontal stabs, which will double as a slot through which the trim tab actuator arm will protrude. My question is what material (plastic??) will work bond to the fabric to accept the nut plates or tinnermans? I am using the Airtech process. Any thoughts?
Thanks
Dave
 

Latest posts

Back
Top