I
i am looking at the Steen Aero S1C plans for the aileron hinge. Is the 4130 brackets that you make to weld the RE3H5 bearing to .050 thick or .030 thick. It’s hard to read. It’s number. -31 on the chart. Thanks
-
Become a Subscribing Member today!
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.
Why become a Subscribing Member?
- In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
- We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
- Annual membership also comes with two BiplaneForum.com decals.
Become a Subscribing Member and access the Biplane Forum in full!
Pitts S1C aileron hinge question
- Thread starter bentonbee
- Start date
- Joined
- Jan 24, 2008
- Messages
- 3,632
- Reaction score
- 2,268
