• Become a Subscribing Member today!

    The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.

    Why become a Subscribing Member?

    • In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
    • We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
    • Annual membership also comes with two BiplaneForum.com decals.

    Become a Subscribing Member and access the Biplane Forum in full!

    Subscribe Now

'Ram Air' Intake Design

Shop deals on ebay
Advertise with us
shop deals on amazon
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Youngman1

Youngman1

Well-Known Member
Supporting Member
*
Joined
Jul 6, 2016
Messages
83
Reaction score
74
Hi All

Just finished my cowling and now looking to make an engine air intake.

Does anybody have a design that I could use for this? Ideally digitally so that I could 3D print and create moulds. The geometry is likely to be quite complex.

Any help greatly appreciated.
 
You must log in or register to reply here.

Similar threads

kato747
Air scoop mod on Starduster
Replies
16
Views
1K
PittsDriver68
P
R
Cowling repair / replace
2 3 4
Replies
76
Views
6K
Larry Lyons
Larry Lyons
Dave Baxter
Acroduster Too History N5462 The ProtoType
Replies
5
Views
2K
EAABipe40FF
EAABipe40FF
Polar
S1-11B Planning: Any Recommendations?
5 6 7
Replies
130
Views
14K
ignacy
ignacy
Youngman1
Whirlwind 200AC RPM Issue
Replies
5
Views
1K
Ralsmark
Ralsmark

Latest posts

Back
Top