Hi all,
I am new to the forum but have read it avidly for a while now.
I have searched the forum for an answer to this but have not found anything.
I am currently building an S1 and would like to route the shoulder harness high, up through the turtledeck, as per the S1T. I have seen it requires a steel structure inside the turtledeck but was hoping someone here would have some drawing I could use. I would like details as to where the harness mounts to the fuselage and what the metalwork in the turtledeck is. I need to get it approved by the LAA in the UK and this should be simple if its identical to the S1T (fingers crossed)!
Thanks in advance,
Chris
I am new to the forum but have read it avidly for a while now.
I have searched the forum for an answer to this but have not found anything.
I am currently building an S1 and would like to route the shoulder harness high, up through the turtledeck, as per the S1T. I have seen it requires a steel structure inside the turtledeck but was hoping someone here would have some drawing I could use. I would like details as to where the harness mounts to the fuselage and what the metalwork in the turtledeck is. I need to get it approved by the LAA in the UK and this should be simple if its identical to the S1T (fingers crossed)!
Thanks in advance,
Chris