Scottly, Jerry, Mark and any others building the D version,
We recently ordered our sway and stagger wires from Steen. After some
fine tuning David Stone finalized our order but asked us to drill the
forward sway wire mounts out to 3/8" holes. This is to accommodate the
appropriate AN fitting at the wire end. The stagger wire holes are fine as drawn. I think we will clamp another
piece over the piece to move the hole further in and not end up with
less material at the edge. You may want to make a note in your plans
and adjust before you make these fittings.
Jim
We recently ordered our sway and stagger wires from Steen. After some
fine tuning David Stone finalized our order but asked us to drill the
forward sway wire mounts out to 3/8" holes. This is to accommodate the
appropriate AN fitting at the wire end. The stagger wire holes are fine as drawn. I think we will clamp another
piece over the piece to move the hole further in and not end up with
less material at the edge. You may want to make a note in your plans
and adjust before you make these fittings.
Jim