- Joined
- Jan 17, 2007
- Messages
- 417
- Reaction score
- 277
I am working on cutting my spar crush plates.
As I was looking at pictures on the net I see some people have used the 12 ply plywood for these.
I am using some 1/4in 90 degree birch faced 5 ply plywood from wicks. Is this good enough or should I move up to 12 ply????
Thanks
Bill
As I was looking at pictures on the net I see some people have used the 12 ply plywood for these.
I am using some 1/4in 90 degree birch faced 5 ply plywood from wicks. Is this good enough or should I move up to 12 ply????
Thanks
Bill
