- Joined
- Jul 18, 2007
- Messages
- 962
- Reaction score
- 86
Hi
I wish to line up the slave strut with the I strut.In this area,the plywood crush plates are1/4" thick each side of the spars,but the aileron hinge and the bellcranck bracket need 1/8" plywood crush plate.I think that if I couldglu 1/8" plywood crush plate on theback of the rear spar,for the aileron hinge;then add a 1/8" plywood to the 1/4" crush plate on the front of the spar...Easy to do,and Iget the same strength;but the bellcranck bracket will be bolded on 3/8" thick crush plate...far from the original 1/8".
What could be the key to do that right.
Cheers.
Jean-luc
I wish to line up the slave strut with the I strut.In this area,the plywood crush plates are1/4" thick each side of the spars,but the aileron hinge and the bellcranck bracket need 1/8" plywood crush plate.I think that if I couldglu 1/8" plywood crush plate on theback of the rear spar,for the aileron hinge;then add a 1/8" plywood to the 1/4" crush plate on the front of the spar...Easy to do,and Iget the same strength;but the bellcranck bracket will be bolded on 3/8" thick crush plate...far from the original 1/8".
What could be the key to do that right.
Cheers.
Jean-luc