• Become a Subscribing Member today!

    The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.

    Why become a Subscribing Member?

    • In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
    • We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
    • Annual membership also comes with two BiplaneForum.com decals.

    Become a Subscribing Member and access the Biplane Forum in full!

    Subscribe Now

Source for hand reamers and sizes?

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jerry

Radial Skybolt Builder: 220.45% completed
*
Joined
Aug 21, 2006
Messages
4,784
Reaction score
716
Location
South Jersey
Looking for a good, relatively inexpensive source for hand reamers. I'm looking for the off sizes that I can slightly enlarge the hole so, say, a 3/8" hole doesn't scrape the plating off a 3/8" bolt. I've looked at both Grainger and MSC.

And by the way... what over-sized reamer would be best for:
3/16"
3/8"
7/16"

Thanks,
Jerry
 
Last edited:

Latest posts

Back
Top