- Joined
- Dec 17, 2010
- Messages
- 132
- Reaction score
- 32
...well, I'm tired of posting about it! Here's where I stand with the wires:
Right Wing
-.1* dihedral on the top with the following tensions
Rear back flying (RBF) - 450
Rear front flying (RFF) - 500
Back landing (BL) - 700
Front landing (FL) - 850 :-(
Front back flying (FBF) - 300
Front front flying (FFF) - 350
Left Wing
-.1* dihedral
RBF - 500
RFF - 500
BL - 750
FL - 775
FBF - 250 :-(
FFF - 300
Center section is .07 right side low
How do I make it better, start over again? Should I fly it and see how things settle out? All advice welcome!
Right Wing
-.1* dihedral on the top with the following tensions
Rear back flying (RBF) - 450
Rear front flying (RFF) - 500
Back landing (BL) - 700
Front landing (FL) - 850 :-(
Front back flying (FBF) - 300
Front front flying (FFF) - 350
Left Wing
-.1* dihedral
RBF - 500
RFF - 500
BL - 750
FL - 775
FBF - 250 :-(
FFF - 300
Center section is .07 right side low
How do I make it better, start over again? Should I fly it and see how things settle out? All advice welcome!