FreeSparrow
Active Member
- Joined
- Jul 19, 2011
- Messages
- 33
- Reaction score
- 0
Folks, I have a question.
I have an Acroduster II with AIO360.
It is tail heavy and requires nose down trimming (see picture).
My mechanic increased the elevator incidence by 3.5 deg. but this is still not enough. There still is a 4 deg angle between the elevator and the horizontal tail. Any ideas? should I replace the bolt (We are the last 2 threads there)?
Thank you,
Avi (FreeSparrow)
I have an Acroduster II with AIO360.
It is tail heavy and requires nose down trimming (see picture).
My mechanic increased the elevator incidence by 3.5 deg. but this is still not enough. There still is a 4 deg angle between the elevator and the horizontal tail. Any ideas? should I replace the bolt (We are the last 2 threads there)?
Thank you,
Avi (FreeSparrow)