compression tube Wing drawing 100-200

[SkyoteTom]

I have run into some confusion on drawing 100-200 Wing assembly. At the aft spar attachment location the landing wire fitting encroaches into the space allocated for the 1inch Compression tube fitting. The Compression tube fittings are made from 1in square tube , The Spar attachment holes are spaced 1.375 oc, when the AN3 hex head is in position and the landing wire fitting is in position approximately .85in is available. All dimensions are accurate to those depicted on 100-200. Reducing the landing wire ftg shoulder would be pretty severe leaving approximately a 1./16in shoulder. I suppose I could insert a .090 thick shim between the spar plate and compression tube fitting ( that's the thickness of the offending landing wire fitting.) . Hopefully someone out there has crossed this Skyote bridge and can comment accordingly. If anyone has an uncovered wing a quick look would tell the story as well. According to the cartoons the assembly should be spar attachment plate, landing wire fitting, brace wire lug, compression tube fitting, no spacer is depicted... Also I presume the compression tube nominal lengths depicted include the .060 end caps, . thanks to all in advance. Tom