• Become a Subscribing Member today!

    The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.

    Why become a Subscribing Member?

    • In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
    • We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
    • Annual membership also comes with two BiplaneForum.com decals.

    Become a Subscribing Member and access the Biplane Forum in full!

    Subscribe Now

Tube Notching & Lathes

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Aug 17, 2009
Messages
13
Reaction score
0


For those of you who use or have used metal lathes to notch tubes, what size lathes are adequate for thin walled 4130 tubing? Size being defined as swing over bed and motor horsepower.
 

Latest posts

Back
Top