We haven't had time for many pics lately but here is one of our latest endeavors. We jigged up the spars level on the table using a simple l-shaped support.
For the trailing edge we made some t-shaped supports to get the bow to plane in with the centerline of the wing.
Here are the nose ribs-
And the wing section as it stands now is below. One of the buckets is behind in painting due to a run in the paint. It will be a few weeks before another paint session. We still need to drill vent holes in all four of the skinned center ribs and create a path for the fuel tank sender wires. We also have alot of clearcoating to do. Once we have the last hardware piece painted, we will final assemble what we have and install the bottom plywood skin.
For the trailing edge we made some t-shaped supports to get the bow to plane in with the centerline of the wing.
Here are the nose ribs-
And the wing section as it stands now is below. One of the buckets is behind in painting due to a run in the paint. It will be a few weeks before another paint session. We still need to drill vent holes in all four of the skinned center ribs and create a path for the fuel tank sender wires. We also have alot of clearcoating to do. Once we have the last hardware piece painted, we will final assemble what we have and install the bottom plywood skin.
